Many owners have no idea how to handle the aged wallpaper in the wall when replacing the wallpaper; if you continue to paste fresh wallpaper on the previous wallpaper, the old and older wallpapers may fall off the beaten track together because of the wetness of the adhesive. The easiest method to do this is certainly to strip the outdated wallpaper so that the wall structure covering sticks to the wall structure more firmly.
Here are some ways to uncover old wallpapers.
Peelable wallpaper
1. Pick out an inconspicuous corner at the top of the wall and utilize the suggestion of the utility knife to get the wallpaper.
2. Try to be near to the wall, pinch the corner of the wallpaper, and try to take it off from the wall. Strip the wallpaper in your direction, which makes it easier to take away the wallpaper. Whether it’s a peelable wallpaper, the wallpaper will detach from the wall structure so long as you are strenuous and moderate.
Cut and infiltrate
1. Use a utility knife, razor blade or wallpaper scraper to cut the previous wallpaper horizontally, each slit is about 20 or 25 cm apart.
2. Apply drinking water or wallpaper remover and wait around a few minutes for the wallpaper to totally saturate.
3. Repeat the same procedure on another wallpaper strip, then return to the initial strip and re-wet it from top to bottom with the formulation.
4. Start stripping the wallpaper with a multi-purpose edging knife with a 8.9 cm wide, movable blade. Beginning with a trim Pure paper Wallpapers horizontal wallet, the blade is positioned under its upper edge and the blade reaches an angle of 30 degrees to the horizontal, and the sliding blade scrapes the wetted wallpaper. A wallpaper that is the same width as the squeegee will fall off the blade and roll onto the squeegee as the blade pushes down.
5. Continue to push down before wallpaper can no longer be taken off. If the scraped wallpaper tape breaks, re-infiltrate this region and start to scrape another tape.
Steam method
It is not simple to peel off aged wallpaper. You can lease a steam engine, but you still need to make use of a wide-blade putty knife to scrape most of the wallpaper.
1. After the water is scorching, press the steam plate on the wall structure before wallpaper on the edge of the steam plate turns into dark due to moisture. Start with a strip of paper and gradually peel from the lime the wallpaper throughout.
2. After steaming half of the paper strip, use a nail or a utility knife to draw up the part of the very best of the wallpaper and tear off the wallpaper. If the wallpaper can’t be removed, it could be scraped off with a wall scraper. You might want to steam the same region twice or three times to loosen the adhesive for the much longer weeks of the wallpaper.
alcohol
For waterproof coatings, cleaning the wall structure paper glue with alcoholic beverages will not cause much harm to the wall. Instead, the volatilization of alcoholic beverages can minimize the damage to the wall. But one thing to notice is that the focus of alcohol shouldn’t be too high. Usually, the volatility can be too big, and it is easy to make the white wall structure turn yellow or dark. This is a very bad phenomenon.
salt
This method uses physical friction. But because salt is a white crystal, you don’t have to worry about the strange color that the friction brings to the wall structure. In the process of rubbing, you may use white gauze or cloth that can keep salt, pack a little packet of salt, carefully rub, gradually you will see that the glue still left on the wall structure paper is slowly disappearing, and then stuck in On the top of the fabric, you just need to rub and stop to eliminate the glue from the gauze. The next phase is not to be said.